Engine Running Behavior; Replacing The Starter Rope And Rewind Spring - Stihl FS 260 C Instruction Manual

English
Installing the Spark Plug
Screw the spark plug into the
N
cylinder.
Press the spark plug boot firmly
N
onto the spark plug.
4
3
2
Fit the cap (1) on the shroud from
N
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
Swing the cap forwards onto the
N
shroud, insert and tighten down the
screw (4) firmly.
34

Engine Running Behavior

If engine running behavior is still
unsatisfactory after the air filter has been
serviced and the carburetor and throttle
cable have been adjusted correctly, the
cause may also be in the muffler.
Have the muffler checked for
contamination (coking) by a servicing
dealer!
STIHL recommends that maintenance
and repair work be carried out only by
authorized STIHL dealers.
Replacing the Starter Rope
and Rewind Spring
Removing the Rewind Starter
1
1
Take out the screws (1).
N
Lift away the rewind starter.
N
Replacing the Starter Rope and Rewind
Spring
If either the starter rope or rewind
N
spring is broken, continue with
"Removing the Rope Rotor".
If either the starter rope or rewind
N
spring are being replaced as a
precautionary measure, continue
with the following chapter.
FS 260 C, FS 360 C
1
1