Shroud - Stihl FS 94 Instruction Manual

Installing
– Clean the sealing face.
– Lubricate sealing lips of new oil
seal with grease, b 12
2
1
: Fit the installing sleeve (1)
1146 893 4600.
: Slip the oil seal (2), sealing lip
facing the crankcase, over the
installing sleeve.
– Remove the installing sleeve.
2
1
: Fit the press sleeve (1)
4149 893 2400 with the larger
diameter (25 mm) facing the
crankcase and press home the oil
seal (2).
The seating face must be flat and
free from burrs.
24
1
: Use hexagon (arrow) to screw
carrier (1) into place clockwise,
then tighten it down firmly.
– Reassemble all other parts in the
reverse sequence.
5.4

Shroud

– Remove the rewind starter,
b 7.2
1
: Take out the screws (1) and
remove the shroud (2).
2
: Take out the screw (1) and
remove the cover (2).
Installing
4
: Fit the shroud (1) so that the tabs
(arrows) engage between the
crankcase (2) and fan
housing (3).
: Insert and tighten down the
screws (4) firmly.
– Install the rewind starter, b 7.2
1
2
1
: Push tab of cover (1) into
opening in shroud and fit cover in
position.
: Insert and tighten down the
screw (2) firmly.
1
1
4
3 2
2
Series 4149 Powerhead