Fuel Suction Hose; Return Hose And Manual Fuel Pump - Stihl FS 94 Instruction Manual

1
– Use STIHL press fluid to make
installation easier, b 12
: Push the fuel suction hose (1)
into the housing bore as far as
stop so that pointed end of the
flange faces the recess (arrow).
– Install the tank housing, b 10.9
3
– Use STIHL press fluid to make
installation easier, b 12
: Fit the elbow connector (1) with
fuel suction hose (3) under the
tank vent hose.
84
: Push the elbow connector (1)
into the fuel suction hose (2) so
that fuel suction hose (3) locates
in the recess (arrow)
– the elbow connector (1) must
be pushed fully into the fuel
suction hose (2).
1
: Use hook 5910 893 8800 to pull
the end of the fuel suction
hose (1) out of the fuel tank.
Do not overstretch the fuel suction
hose.
1
– Fit the pickup body, b 10.8.1
2
– Close the tank cap.
– Reassemble all other parts in the
reverse sequence.
10.8.4 Fuel Hose / Fuel Return
Hose and Manual Fuel
Pump
– Open the tank cap.
– Remove the shroud, b 5.4
– Remove the filter cover, b 10.1
1
: Pry the fuel return hose (1) out of
the bore (arrow) in the tank
housing.
1
: Pull the fuel hose (1) off the
connector (arrow) on the
carburetor.
1
: Squeeze locking tabs (arrows)
under the retainer (1) together
and push out the manual fuel
pump (2).
– Remove manual fuel pump with
fuel hoses.
Series 4149 Powerhead
2