Flywheel - Stihl FS 94 Instruction Manual

Installing
– If the ignition module is new, use
a pointed tool to pierce the center
of the ignition lead's insulation,
about 15 mm from the end of the
lead.
: Pinch the hook of the leg spring
into the pierced hole in the center
of the lead (arrow).
– Coat the inside of the spark plug
boot with
STIHL press fluid, b 12
: Hold the ignition lead and leg
spring together and push them
into the spark plug boot.
Series 4149 Powerhead
: Make sure the leg spring (arrow)
locates properly inside the spark
plug boot.
: Fit the boot (1) on the spark plug
and arrange it so that the ignition
lead is positioned in the recess
(arrows) in the air guide shroud
– Reassemble all other parts in the
reverse sequence.
6.5

Flywheel

– Remove the shroud, b 5.4
– Remove the fan housing, b 4.1
– Use locking strip to block the
piston, b 4.2
– Remove the clutch, b 4.2
1
1
: Unscrew the flywheel nut (1).
1
2
: Apply the puller (1)
4119 890 4501, insert screws (2)
from clutch and tighten them
down firmly.
: Screw home the thrust bolt (3)
clockwise until the flywheel is
released. Remove the flywheel.
– Remove the puller (3)
4119 890 4501 from the flywheel.
2
3
39