Short Circuit Wire And Contact Springs; Removing And - Stihl FS 94 Instruction Manual

3
: Press the short circuit wire (1)
into the guide (arrow).
: Connect short circuit wire's flag
terminal (2) to the ignition
module (3) so that its crimped
side faces the engine.
1
: Starting at the flag terminal, push
the short circuit wire (1) snugly
into the guides (arrows).
1
: Push the ground wire (1) into the
guide (arrow).
– Ground wire must be under the
short circuit wire.
42
: Connect short circuit wire's flag
2
terminal (2) to the tag (3) so that
its crimped side faces the
carburetor.
1
– Reassemble all other parts in the
reverse sequence.
6.6.3 Short Circuit Wire and
Contact Springs on
Control Handle

– Removing and

Installing
– Remove the throttle trigger and
lockout lever, b 9.3
– Remove stop switch lever, b 9.4
: Push the contact spring (1)
inwards in area of terminal (2)
and lift it over the lug (arrow).
: Pull the contact spring (1) with
short circuit wire out of the
guides.
2
3
: Pull the contact spring (1) with
ground wire out of the guides
(arrows).
2 1
: Disconnect contact springs (1, 2)
from the ground and short circuit
wires.
– Inspect the contact springs,
replace if necessary – contact
springs must not be twisted.
– Remove the throttle cable and
short circuit wire from the engine,
b 6.6.2
1
1
2
Series 4149 Powerhead