6.6.2
Short Circuit Wire
on Engine
– Removing and
Installing
– If necessary, remove the drive
tube, b 9.1
– Remove the shroud, b 5.4
– Pull boot off the spark plug.
3
1
3
2
: Take out the screws (1) or
screw (2) and remove the filter
cover (3).
Series 4149 Powerhead
2
: Disconnect ground wire
terminal (1) and short circuit wire
terminal (2).
: Pull the ground and short circuit
wires out of the guides (arrows).
1
2
: Turn the control valve lever (1) in
direction of full throttle, push the
throttle cable (2) out of its seat
(arrow) and remove it.
3
2
: Take out the screw (1) and
remove the cable holder (2) with
protective tube (3).
: Check the cable holder (2),
replace throttle cable if
necessary.
– Remove the short circuit wire
from the control handle, b 6.6.3
1
Installing
– Fit the short circuit wire in the
control handle, b 6.6.3
1
1
2
: Fit the cable holder (1) on the
control valve (2) so that it and the
protective tube fully engage the
seat (arrows).
: Insert and tighten down the
screw (3) firmly.
1
: Turn the control valve lever (1) in
direction of full throttle and
engage the throttle cable (2) in its
seat (arrow).
3
1
2
41