Stihl FS 94 Instruction Manual page 18

: Install circlip (1) at the other side.
– Remove the sleeve and rubber
element, b 8.1
3
1
2
4
: Fit the fan housing (1) with clutch
drum (2) over the clutch (3) and
line it up so that the pins (4)
engage the holes (arrows) in the
crankcase.
1
: Tighten the screw (1) until the fan
housing is seated
– the upper screws are not fitted
and secured until the shroud is
installed – do not finally tighten
screw (1) yet.
Series 4149 Powerhead
– Install the drive tube, b 9.1
– Fit the shroud, b 5.4
1
1
: Fit screws (1), then tighten down
screw (2) and screws (1) firmly.
– Install the rewind starter, b 7.2
4
: The throttle cable (1) must not be
under tension.
4.2
– Remove the fan housing, b 4.1
1
2
: Pull boot (1) off the spark plug.
– Unscrew the spark plug.
1
: Insert locking strip (1)
0000 893 5904 in the cylinder.
Clutch
1
1
17