NURIT 8000
Figure 14-2 SAM or SIM Cardholder Locking-Clasp
1
Locking clasp
4. Lift the cardholder on its hinge to an upright position.
5. Hold the SAM or SIM card so that its chip side is facing
down towards the contacts on the reader.
6. Insert the end closest to the chip on the SAM or SIM card
into the cardholder.
Make sure that you first slide the end closest to the
chip on the card into the grooves of the holder.
1
3
Figure 14-3 SAM or SIM Card Installation
1
SAM or SIM card
3
Metal contact
7. Close the SAM or SIM cardholder.
8. Lock the cardholder by sliding the cardholder locking clasp
in the direction indicated by the engraved arrow to the
LOCK position.
9. If necessary, replace the battery, as described on page 21.
Installation Manual
1
Note
2
4
2
Beveled corner
4
Triangular protrusion
33