Installing Sim, Sam, And Sd Cards - VeriFone 8000 Installation Manual

S
ETUP

Installing SIM, SAM, and SD Cards

To replace the battery
pack/card
compartment cover
Installing SIM,
SAM, and SD
Cards
NOTE
To install a SIM or a
SAM card
NOTE
1
Place the NURIT 8000 face down on a soft, smooth surface, so as not to
damage the LCD screen.
Figure 5 Replacing the Battery/Card Compartment Cover
2
Insert the two hinges of the battery/card compartment cover into the hinge
slots on the edge of the battery/card compartment.
3
Close the compartment cover and press down until the locking tab snaps into
place.
4
Connect the AC/DC power adapter from the electrical power outlet.
Configuration of SIM, SAM, and SD cards are model dependent. You can install
one SIM card, up to two SAM cards, and an SD card in the NURIT 8000 terminal,
depending on the particular model.
The card compartment is shared with the battery. To gain access to the battery/
card compartment, you must first remove the battery/card compartment door. For
information on removing and replacing the battery/card compartment door, see
Opening and Closing Battery/Card Compartment
A SIM card must be installed when using a model of the NURIT 8000 that
implements GSM or GPRS wireless communications technology.
1
Remove the battery/card compartment door. See
2
If necessary, remove the battery. See
3
Slide the locking-clasp in the direction indicated by the engraved arrow to the
position.
OPEN
4
Lift the cardholder on its hinge to a vertical position.
5
Hold the SIM/SAM card vertically, with the beveled corner at the top edge and
the metallic contacts facing towards the contacts on the reader.
6
Slide the card into the cardholder.
Make sure that you first slide the end closest to the chip on the card into the
grooves of the holder and that the beveled corner is on the top edge of the SAM
card.
Cover.
Figure 4.
Figure 10.
NURIT 8000 I
NSTALLATION
15
G
UIDE