Installing The Tank Vent And Emergency Vent - Saturn 125 Operator's Manual

Oil Tank Installation Specifications (continued)
TANK VENT KITS AVAILABLE FROM CLEAN BURN:
CB Part # 70380 − 4" Tank Vent Kit
(2) elbows
(2) 6" nipples
(1) mushroom cap vent
(1) emergency vent
MUSHROOM
CAP VENT
STEEL PIPE
(USER SUPPLIED)
EMERGENCY
VENT
CLEAN−OUT
(TANK DRAIN)
Figure 4F - Typical Metering Pump Installation with Inside Tank

Installing the Tank Vent and Emergency Vent

Some codes require that you install a tank vent (to the outside) and an emergency vent for your tank as shown
in Figure 4F. Tank Vent Kits are available from Clean Burn; contact your local Clean Burn dealer to order.
Be sure to check your local codes for any additional tank installation requirements, and adhere to the following
installation guidelines:
• Install a length of minimum 2" steel pipe (user-supplied) terminating outside with a proper
vent cap as shown in Figure 4F. Consult local codes for information and requirements
concerning the proper venting of oil storage tanks.
• Install an emergency vent as shown in Figure 4F. Contact your tank manufacturer for
information concerning the proper emergency vent for your tank.
Operator's Manual: Models Saturn™ 140 & Saturn™ 230
PRESSURE
RELIEF OIL
LINE BACK TO
THE TANK
FUNNEL WITH
BALL VALVE
PRESSURE
LINE
4-8
PUMP
SUCTION LINE
ASSEMBLY
CHECK
VALVE
FILTER
SCREEN