Mpls L3Vpn Packet Forwarding - HP FlexNetwork 10500 Series Configuration Manual

Hide thumbs Also See for FlexNetwork 10500 Series:
Table of Contents

Advertisement

d. Advertises those routes to the connected CE over a static route, RIP route, OSPF route,
IS-IS route, EBGP route, or IBGP route.

MPLS L3VPN packet forwarding

In a basic MPLS L3VPN (within a single AS), a PE adds the following information into VPN packets:
Outer tag—Identifies the public tunnel from the local PE to the remote PE. The public tunnel
can be an LSP or an MPLS TE tunnel. Based on the outer tag, a VPN packet can be forwarded
along the public tunnel to the remote PE. For an LSP or MPLS TE tunnel, the outer tag is an
MPLS label.
Inner label—Identifies the remote VPN site. The remote PE uses the inner label to forward
packets to the target VPN site. MP-BGP advertises inner labels for VPN-IPv4 routes among
PEs.
Figure 48 VPN packet forwarding
Site 1
2.1.1.1/24
1.1.1.2
As shown in
process:
1.
Site 1 sends an IP packet with the destination address 1.1.1.2. CE 1 transmits the packet to PE
1.
2.
PE 1 performs the following operations:
a. Finds the matching VPN route based on the inbound interface and destination address of
the packet.
b. Labels the packet with both the inner label and the outer tag.
c. Forwards the packet to the public tunnel.
3.
P devices forward the packet to PE 2 by the outer tag.
The MPLS label is removed from the packet at the penultimate hop.
4.
PE 2 performs the following operations:
a. Uses the inner label to find the matching VPN instance to which the destination address of
the packet belongs.
b. Looks up the routing table of the VPN instance for the output interface.
c. Removes the inner label and forwards the packet out of the interface to CE 2.
5.
CE 2 transmits the packet to the destination through IP forwarding.
When two sites of a VPN are connected to the same PE, the PE directly forwards packets between
the two sites through the VPN routing table without adding any tag or label.
CE 1
P
PE 1
Outer tag
Inner label
1.1.1.2
Figure
48, a VPN packet is forwarded from Site 1 to Site 2 by using the following
P
PE 2
MPLS network
Inner label
1.1.1.2
188
Site 2
CE 2
1.1.1.2/24
1.1.1.2

Advertisement

Table of Contents
loading

Table of Contents