HP FlexNetwork 10500 Series Configuration Manual page 441

Configuring static routing between an MCE and a PE
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. (Optional.) Set the
default preference for
static routes.
Configuring RIP between an MCE and a PE
Step
1. Enter system view.
2. Create a RIP process for
a VPN instance and enter
RIP view.
3. Enable RIP on the
interface attached to the
specified network.
4. Redistribute the VPN
routes.
Configuring OSPF between an MCE and a PE
Step
1. Enter system view.
2. Create an OSPF process for
a VPN instance and enter
OSPF view.
3. Disable routing loop
detection.
4. Redistribute the VPN routes.
5. Create an OSPF area and
enter OSPF area view.
Command
system-view
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ip route-static default-preference
default-preference
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id |
all-processes | allow-ibgp ]
[ allow-direct | cost cost-value |
route-policy route-policy-name | tag tag ]
*
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
vpn-instance-capability simple
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | nssa-only |
route-policy route-policy-name |
tag tag | type type ] *
area area-id
432
Remarks
N/A
By default, no
static routes are
configured.
The default
preference is 60.
Remarks
N/A
N/A
By default, RIP is disabled on
an interface.
By default, no routes are
redistributed into RIP.
Remarks
N/A
N/A
By default, routing loop detection
is enabled.
You must disable routing loop
detection for a VPN OSPF
process on the MCE. Otherwise,
the MCE does not receive OSPF
routes from the PE.
By default, no routes are
redistributed into OSPF.
By default, no OSPF areas exist.