Ldp Pw Configuration Example - HP FlexNetwork 10500 Series Configuration Manual

VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs

LDP PW configuration example

Network requirements
Configure a VSI on each PE, and establish LDP PWs between the PEs to interconnect the CEs.
Configure an Ethernet service instance on GigabitEthernet 1/0/1 to match packets with an outer
VLAN ID of 100 on each PE. Bind the Ethernet service instance to the VSI to forward the matching
packets through the VSI.
Figure 103 Network diagram
VPN 1
CE 1
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure an IGP and public tunnels on each PE. (Details not shown.)
2. Configure PE 1:
# Configure basic MPLS.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
# Enable L2VPN.
[PE1] l2vpn enable
# Configure VSI aaa that uses LDP as the PW signaling protocol, and establish PWs to PE 2
and PE 3.
[PE1] vsi aaa
[PE1-vsi-aaa] pwsignaling ldp
[PE1-vsi-aaa-ldp] peer 2.2.2.9 pw-id 500
: -
: 0x260000002
: 1028
Loop0
3.3.3.9/32
Vlan-int30
30.1.1.3/24
PE 3
PE 1
Vlan-int30
30.1.1.1/24 40.1.1.2/24
Vlan-int20
GE1/0/1
20.1.1.1/24 20.1.1.2/24
Loop0
1.1.1.9/32
VPN 1
GE1/0/1
CE 3
Vlan-int40
40.1.1.3/24
PE 2
Vlan-int40
GE1/0/1
Vlan-int20
Loop0
2.2.2.9/32
CE 2
392
VPN 1