Brother GTX-4 Instruction Manual page 36

1st layer
[Nozzle Check CMYK]
[Test Print]
[Nozzle Check White]
[Print Data Load]
[Receiving History]
[White Ink Circulation]
[White Ink Refilling]
[Maintenance Part
Clean/Replace]
[White Head Cleaning]
[Install White Ink After Cleaning]
[Maintenance]
[Head Replacement]
[Install Ink after Replacing Head]
[Initial Ink Installation]
[White Ink Pause Mode]
[Exchange Filter]
[Log copy to USB]
[Print Direction]
[Back Light]
[Auto Screen Erase Time]
[Menu TimeOut Setting]
[Speaker Volume]
[Temperature]
[Low Temperature Mode]
[Printer Setting] [Auto Cleaning Setting]
[Auto Cleaning Start Timing]
[CR Speed Adjustment]
[Flushing Interval Setting]
[Flushing Volume Setting]
[Auto Job Delete]
[Rcvng Prnt Setting]
[IP Address Set]
2nd layer
This is the test pattern to check to see if ink-jet droplets are
ejected from the color heads properly or not.
This is the test pattern to check to see if ink-jet droplets are
ejected from the white head(s) properly or not.
With this menu item, any print data stored in a USB flash
memory (ARX4 file) is loaded into the system.
By selecting this menu item, you can display any print data
received in the order in which they are sorted from the
newest to the oldest ones, and you can select any one of
them.
For details, please refer to "6. Basic printing procedures
>>P.122", "7. Precautions to keep good printing quality/use
printer over the long term >>P.172", or "9. Troubleshooting
>>P.235".
For details, please refer to "7. Precautions to keep good
printing quality/use printer over the long term >>P.172" or "8.
What to do when needed >>P.222".
36
Description
Menu list