Brother GTX-4 Instruction Manual page 151

On the operation panel, press
(1)
(2) Slide the 16X21 platen while lifting it a little to draw it forward.
(3) Perform the work for placing or removing a T-shirt and replacing the platen in this condition.
<TIPS>

For information on replacing the platen, refer to "6-4-1. Replacing the currently used platen with another one >>P.143".

For information on placing or removing a T-shirt, refer to "6-5. Placing print medium in position >>P.152".
(4) When you finish placing or removing a T-shirt, and replacing the platen, slide the platen backward and return it to its
printing position.
<IMPORTANT>

As the platen is positioned higher when it is slid forward, it is detected by the obstacle sensor, which prevents printing from
being performed. However, if the platen's height is set at the lowest position, the platen is not detected by the obstacle
sensor, and printing may be performed outside the print range of the platen.
Make sure to start printing after sliding the platen to the printing position.
, and move the 16x21 platen toward the front of the printer.
Replace the platen
Slide it forward
16X21 platen
Slide it backward
151
Basic printing procedures
X0166
X0168