JVC MX-G68V Service Manual page 9

Removing the power ICs
Prior to performing the following procedure, remove
the metal cover, CD changer unit, heat sink &
amplifier board .
1. Remove the four screws P attaching the power ICs
to the heat sink.
2. Unsolder the power ICs solder point.
Removing the power transformer
Prior to performing the following procedure, remove
the metal cover, CD changer unit, heat sink &
amplifier board, tuner board and rear cover.
1. Disconnect the power cord from connector RCW2 of
the power transformer board.
2. Disconnect the harness from connector PCW1 of the
power transformer board.
3. Remove the four screws Q attaching the power
transformer.
(See Fig.16 and 17)
(See Fig.18)
Heat sink
Power ICs solder point
Heat sink
Power transformer
PCW1
Q
MX-G68V/MX-G65V
P
Fig.16
Amplifier board
Fig.17
RCW2
Q
Power cord
Fig.18
1-9