JVC MX-G68V Service Manual page 12

MX-G68V/MX-G65V
Removing the sensor board / the turn
table motor assembly
Prior to performing the following procedure, remove
the CD tray.
1. Remove the screw A attaching the sensor board and
release the two tabs b attaching the sensor board on
the under side of the CD tray.
2. Disconnect the harness from connector CW1 on the
sensor board and release the harness from the two
hooks c. Remove the sensor board.
3. Remove the screw B attaching the turn table. Detach
the turn table from the tray.
4. Pull outward the tab marked d attaching the turn
table motor assembly on the upper side of the tray
and detach the turn table motor assembly from the
tray.
Removing the belt, the Video CD board
Prior to performing the following procedure, remove
the CD tray.
1. Disconnect the harness from connector on the CD
mechanism board in the CD mechanism assembly
on the under side of the CD changer unit. Disconnect
the card wire from the pickup unit connector.
2. Detach the belt from the pulley on the upper side of
the CD changer unit (Do not stain the belt with
grease).
3. Disconnect the card wire from the connector SW1 on
the Video CD board.
Remove the three screws D attaching the video CD
board. First release the three tabs f and tabs e
attaching the video CD board motor to raise the
video CD board slightly, then release the video CD
board.
If the tabs e and f are hard to release, it is
recommendable to unsolder the two soldered points
on the motor terminal of the video CD board.
1-12
(See Fig.6 to 8)
(See Fig.9 and 10)
c
Tab b
Fig.6
Tray
Fig.7
Turn table motor assembly
Fig.8
CD changer unit
Fig.9
A
Tab b
CW1
Sensor board
Turn table
B
d
Motor
Belt