JVC MX-G68V Service Manual page 6

MX-G68V/MX-G65V
UCW3
Front panel
assembly
FLdispaly & system
control board
Rear panel
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and the CD changer unit.
1. Disconnect the card wire from connector FCW3 and
the harness from connector JCW1, JCW2 ECW1
and HCW3 on the inner side of the main board in the
body.
2. Remove the two screws E attaching the front panel
assembly on both sides of the body.
3. Remove the screw F attaching the earth terminal
extending from the cassette mechanism assembly.
4. Remove the screw G attaching the front panel
assembly and main board.
5. Remove the screw H attaching the front panel
assembly on the bottom of the body.
6. Release the two joints a on both sides and two joints
b on the bottom of the body using a screwdriver.
1-6
Fig.4
Adhesive card wire strap
CD changer unit
Fig.6a
Front panel assembly
(See Fig.7 to 9 )
RCW6
Rear panel
D
D
Front panel assembly
Joint a
E
Fig.5
CD changer unit
Fig.6b
FCW3
JCW2
ECW1
JCW1
HCW3
Earth wire F
Fig.7
C
Rear panel
Main board