JVC MX-G68V Service Manual page 10

MX-G68V/MX-G65V
<Front panel assembly>
Prior to performing the following procedure, remove
the metal cover, the CD changer unit and the front
panel assembly.
Removing the power switch board
1. Disconnect the card wire from connector UCW1 of
the power switch board.
2. Remove the five screws R attaching the power
switch board and release the tab c outward.
Removing the FL display & system
control board
1. Disconnect the card wire from the connectors
UCW3, UCW5,UCW6 and UJW5 on the FL display &
system control board.
2. Remove the five screws S attaching the FL display &
system board.
3. Disconnect the card wire from the connector UCW2
on the FL display & system control board.
Removing the headphone board
Prior to performing the following procedure remove
the FL display & system control board.
1. You can pull out the headphone board.
Removing the front board / MIC board
Prior to performing the following procedure, remove
the FL display & system control board.
1. Pull out the volume knob, subwoofer level knob and
sound mode knob from front side.
2. Remove the eleven screws T attaching the front
board and release the two tabs d outward.
3. Release the two tabs e outward and remove the MIC
board.
Removing the
assembly
1. Disconnect the card wire f from the mechanism
board on the cassette mechanism assembly.
2. Remove the six screws U attaching the cassette
mechanism assembly.
1-10
(See Fig.19)
(See Fig.19)
(See Fig.20)
(See Fig. 20 and 21)
cassette mechanism
(See Fig.20)
Power switch board
UCW2
UCW3
UJW5
S
Front board
T
Tab d
T
Mic board
Card wire f
Tab e
Fig.20
UCW1
R
Tab c
S
FLdiplay & system
control board
S
UCW5
UCW6
Fig.19
T
Headphone
board
T
U
Cassette mechanism assembly
SOUND MODE
knob
SUBWOOFER
LEVEL knob
VOLUME knob
Fig.21