Table of Contents
Advertisement
Select Service Type
The Appendix has a list of Service Types and their general descriptions.
Default is Custom 1.
Scroll to the Service Type and press E/yes.
Set Delay Time
on a channel after the transmission has ended before moving to the next channel.
A negative delay will force a resume after that number of seconds.
The default setting is 2 seconds.
-10, -5, -2, 0, 1, 2, 5, 10, or 30 sec.
Set Priority
This sets the channel as a priority channel while scanning. The
default setting is Off. Note: To use Priority ID Scan you must also enable Priority
ID Scan for each System. See also Priority Scanning.
On or Off
Set Alert
This setting controls when and how the scanner alerts you if the
channel becomes active. The default setting is Off.
Set Alert Tone
Alert 1-9 or Off.
Set Level
Level 1-15 or Auto (the master volume level).
Set Alert Light
Set Color
Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White.
Set Pattern
On, Slow Blink, or Fast Blink.
Set Avoid
This determines whether a channel will be scanned or not.
Temporary L/O means until you cycle power. The default setting is Unlocked.
Temporary Avoid, Stop Avoiding, or Avoid
See also Scan Avoids.
Volume Offset
-3, -2, -1, 0, +1, +2, or +3
Note: You can also toggle volume offset for a channel in scan hold mode by
pressing Func then 0(
Delete Channel
At Confirm Delete? press E/yes or .no.
New Channel
Channel Options
This sets the Service Type for The Channel.
This sets (in seconds) the amount of time the scanner stays
This sets the Volume Offset for the Channel.
).
LVL
Deletes the Channel.
See New Channel.
57
Advertisement
Table of Contents
