Uniden BCD436HP User Manual page 57

Set Location Information
use with Location Control enabled or with a GPS. You can program a circle with a
radial range or multiple rectangles as a location.
See Set Up GPS first to set your units, time zone, etc.
Circle
Set Latitude
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Set Longitude
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Set Range See also Understanding Range.
0-6000
Rectangles
New Rectangle
Latitude -Top Left
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Longitude -Top Left
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Latitude - Right Bottom
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Longitude - Right Bottom
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Rectangle
Edit Rectangle See Rectangles above.
Delete Rectangle
At Confirm Delete? press E/yes or .no.
P25 Waiting Time
determine if channels on mixed Motorola Systems have digital or analog
transmissions. During this time, the scanner will evaluate the received signal and,
if it detects digital data, will open squelch immediately. If digital is not detected
before the delay expires, the scanner will open squelch at the end of this delay.
This is to prevent "false decode" problems. This setting only affects channels with
an Audio Type set to All. The default setting is 400 ms.
0 to 1000
Note: Any analog transmissions will lose the first part of the transmission, up
to the wait time you set here.
Site Options
This allows you program a location for the Site to
(Motorola Only) This setting gives the scanner time to
51