Table of Contents
Advertisement
Set Backlight
Adjust Contrast
Disp. Unit ID
Setting the Backlight
backlight automatically according to backlight setting.
Set Mode Note: (BCD536HP Only) These settings will work only when the
backlight is set to Off with the VOL button and then only at the High intensity.
Squelch
Off - The backlight stays off when the squelch opens.
5 sec - The backlight stays on 5 seconds after the squelch opens.
10 sec - The backlight stays on 10 seconds after the squelch opens.
Open Squelch - The backlight stays on only when the squelch is open.
Keypress
Off - The backlight stays off when any key is pressed.
5 sec - The backlight stays on for 5 seconds when any key is pressed.
10 sec - The backlight stays on for 10 seconds when any key is pressed.
Timeout (BCD436HP Only)
10 sec - Turns the backlight on for 10 seconds when you press
30 sec - Turns the backlight on for 30 seconds when you press
Infinite - The backlight always stays on.
Set Dimmer (BCD536HP Only)
Manual (For non-vehicle use)
High, Middle, Low, or Off.
Auto (For vehicle use)
+ Polarity - If the orange wire gets 12V when you turn on the headlights.
- Polarity - If the orange wire is switched to chassis ground when you
turn on the headlights.
Adjust Contrast
Contrast 1-15
Display Unit ID
on Motorola, EDACS, and APCO P25 systems.
On or Off.
32
Display Options
The scanner will turn on/off the LCD and the Keypad
This setting controls the displays contrast.
Allows you view the unit ID of the radio currently transmitting
Set ID Format (MOT/P25)
Set ID Format (EDCS)
Set Upside-Down (BCD536HP Only)
.
.
Advertisement
Table of Contents
