Hard Drive Cage - HP ProLiant DL360 G7 Maintenance And Service Manual

Remove the hot-plug power supply.
5.
WARNING:
the power cord to the power supply until the power supply is installed.
To replace the component:
Slide the hot-plug power supply into the power supply bay.
1.
Connect the power cord to the power supply.
2.
Install the cable management arm, if removed.
3.
Route the power cord through the cable management arm or power cord anchor.
4.
NOTE:
that the redundant power supply can be removed without disconnecting the power cord from
the primary power supply.
Close the cable management arm.
5.
Connect the power cord to the power source.
6.
Be sure that the power supply LED is green
7.
Be sure that the power supply LED on the SID is green.
8.

Hard drive cage

To remove the component:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Remove all hard drives
3.
To reduce the risk of electric shock or damage to the equipment, do not connect
If using the power cord anchor, be sure to leave enough slack in the power cord so
("SAS and SATA hard
("Rear panel LEDs and buttons" on page 68).
drive" on page 30).
Removal and replacement procedures 32