HP ProLiant DL360 G7 Maintenance And Service Manual page 56

Close the processor retaining latch and the processor socket retaining bracket.
5.
Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
6.
Allow the alcohol to evaporate before continuing.
Apply all the grease to the top of the processor in one of the following patterns to ensure even
7.
distribution.
Install the heatsink ("Heatsink" on page 45).
8.
IMPORTANT:
times (if applicable).
Install all components removed from the failed system board.
9.
IMPORTANT:
system board.
Install the hard drives
10.
Install all power supplies
11.
To ensure proper cooling, be sure the processor air baffle is installed at all
Install all components with the same configuration that was used on the failed
("SAS and SATA hard
("Hot-plug power supply" on page 31).
drive" on page 30).
Removal and replacement procedures 56