Figure 23 Placement Of Communication Filters - Bard Fusion-Tec Installation Instructions Manual

Placement of Communication Wire Filters (Daisy Chain and Alternate Methods)
Place filter here
LV1000
Place filter here
Unit 1
NOTE: Line filters can be on either the unit or controller, whichever device is on the end of the chain. No matter
how many units there are, the two end devices will only have ONE communication cable, whereas the
center devices will all have TWO (as shown above). Filters go inside the unit or controller; shown out of
unit above for identification only.
Manual 2100-674A
Page 26 of 41
FIGURE 23
Daisy Chain Wiring (up to four units)
Unit 1
Alternate Wiring (up to four units)
Unit 2
Unit 2 Unit 3
LV1000*
Place filter here
Unit 4
Place filter here
Unit 3 Unit 4