Table of Contents
Advertisement
Safety and warnings
3
Electrical
This cooker is to be installed and connected to the electricity supply only by an authorised
person.
If the installation requires alterations to the domestic electrical system call, a qualified
electrician. The electrician should also check that the electrical system is suitable for the
electricity drawn by the cooker.
The appliance must be connected to the mains, checking that the voltage corresponds to the
value given in the rating plate and that the electrical cable sections can withstand the load
specified on the plate.
A suitable disconnection switch must be incorporated in the permanent wiring, mounted
and positioned to comply with the local wiring rules and regulations. The switch must
be of an approved type installed in the fixed wiring and provide a 3 mm air gap contact
separation in all poles in accordance with the local wiring rules.
The switch must always be accessible.
The power supply cable must not touch any hot parts and must be positioned so that it does
not exceed 75 °C at any point.
To connect the cooker to the mains, do not use adapters, reducers or branching devices as
they can cause overheating and burning.
This cooker must be connected to a suitable double pole control unit adjacent to the cooker.
No diversity can be applied to this control unit.
If the electrical supply cord is damaged, it must only be replaced by an authorised person.
The cooker must be earthed.
Advertisement
Table of Contents
