Table of Contents
Advertisement
Quick Links
Care and cleaning
Before you start cleaning your cooker, please:
▪ Read these cleaning instructions and the
▪ Turn the cooker off at the wall.
▪ Make sure the cooker is a safe temperature to touch.
▪ Do not use a steam cleaner.
▪ Do not keep flammable substances in the oven.
General advice
▪ Wipe down the cooktop and wipe out the oven after every use.
▪ Wipe up spills. Avoid leaving alkaline or acidic substances (such as lemon juice or vinegar) on the surfaces.
▪ Do not use cleaning products with a chlorine or acidic base.
Cleaning the outside of the cooker
▪ Do not use abrasive cleaners, cloths or pads on the outside surfaces.
▪ Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle.
Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also
be cleaned with a suitable cleaner and polish.
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF...
guide.
'Safety and
warnings' section at the start of this user
Updated: Thu, 06 Jan 2022 15:57:26 GMT
Powered by
1
Advertisement
Table of Contents
Related Manuals for Fisher & Paykel OR90SDBGFPX1
Summary of Contents for Fisher & Paykel OR90SDBGFPX1
- Page 1 ▪ Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle. Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also be cleaned with a suitable cleaner and polish. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
-
Page 2: Burner Parts And Pan Supports
• It is very important to check that the burner flame spreader and the cap have been correctly positioned. Failure to do so can cause serious problems. To avoid damage to the electronic ignition, do not try to light a burner without all burner parts in place https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by... - Page 3 (see Fig.26). Fig. 30 Correct line-up of semi-rapid burner parts Fig. 31 Replacing the semi-rapid burner caps https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 4 Both the ignitor and probe must be very carefully cleaned using a toothbrush and methylated spirits (see Fig.26). Fig. 32b Correct positioning of flame spreader - dual burner Fig. 32a Correct positioning of flame spreader - triple-ring wok burner https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
-
Page 5: Cleaning The Inside Of Your Oven
Removing the side racks 1. Using a small coin or a flat-head screwdriver, loosen and remove the front fixing screw. 2. Slide the side rack clear of the rear lock stud and remove. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by... - Page 6 ▪ the stop notches point down; ▪ the guard rail is at the back. The grill tray should be positioned between the two wires of a shelf position and orientated as shown. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 7 ▪ the slides to the top wire of a shelf position ▪ both sides of each pair of slides ▪ both slides on the same level. Remove the side racks first to make removing the sliding shelf supports easier. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
-
Page 8: Storage Drawer
2. Press the lever on the left guide rail down and the right guide rail up. 3. Holding the levers, disengage and remove the drawer. Do not use excessive force or you may damage the drawer slides. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by... -
Page 9: Replacing The Oven Light Bulbs
The oven light bulbs (12V/20 W halogen) have a very long life, but if you should need to replace one, use only a replacement bulb purchased from your nearest Fisher & Paykel dealer and follow these steps. Oven bulb replacement is not covered by your warranty.. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by... - Page 10 3. Using a flat-head screwdriver, twist and lift the retainer bracket in the back and pull out the faulty bulb. clip upwards to release the glass cover. Hold the glass cover to prevent it falling. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 11 Your oven door has 4 panes of glass. The inner and middle panes may be removed for cleaning. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT...
-
Page 12: Removing The Door
1a. Turn the oven off at the wall. Make sure you have 2. Open the levers on the left and right hinges to their full prepared enough space for resting the door and its glass extent, as shown. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by... - Page 13 5a. Lift the door and disengage the hinges. 5b. Rest the door on a soft surface. Ensure you lay it with the handle side down. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 14 • you take extra care not to bump the edges of the glass against any object or surface. • you do not force any of the panes into place. If you are experiencing difficulties replacing the panes, remove https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT...
- Page 15 2. Take the other middle pane (C) and hold it firmly. Insert it in the next pair of grooves (1), push it slightly towards yourself (2) and gently lower into place (3). https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT...
- Page 16 4. Position the glass retainer, as shown. It should sit on the bottom edge of the outer glass (A). Check that the clamps of the glass retainer are not deformed or damaged. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT...
- Page 17 5. Gently push the glass retainer back into place. You should be able to hear the tabs on both sides click as they lock the glass retainer in. Make sure the glass retainer is correctly and firmly in place and that the glass panes are secure. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 18 4a. Fully close the levers on the left and right hinges, as 3. Open the door to its full extent. shown. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...
- Page 19 Do not continue with the Self Clean cycle if the side racks or shelves are in the oven. If the door lock indicator light does not turn on, or the display shows refer to ‘Troubleshooting’. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFPX1/User_Guide_OR90SDBGF… Updated: Thu, 06 Jan 2022 15:57:26 GMT Powered by...