Table of Contents
Advertisement
Care and cleaning
32
Cleaning the enamel cavity
Do not use oven cleaner, scourers or abrasive cleaners with acid or alkali content on catalytic
panels.
Catalytic panes are normally 'self-cleaning' because their special enamel breaks down greasy
splatters when the oven is used for non-greasy baking, especially at high temperatures. If you
o
seldom bake then, from time to time, heat an empty oven on Bake for 60-90 minutes at 250
C
to break down any greasy soiling.
If you wish to clean the remainder of the oven cavity, first remove the catalytic panels (see
'Fitting side racks and Catalytic panels' .
Clean the enamel on the inside of the oven when it has cooled down, using household
detergents or an ammonia-based cleaner. You may use 'off the shelf' oven cleaners, if you
carefully follow the manufacturers' instructions.
Drop-down grill element
To lower the grill element: use a flat-head screwdriver or a small coin to loosen the element
fixing screws.
When you have finished cleaning the oven ceiling, raise the grill element and screw the element
fixing screws back onto the studs. Make sure that the fixing screws are tightened and the
element is held securely in place.
The grill element itself is self-cleaning.
Fixing screw
Stud
Fig.26 Drop-down grill element
Advertisement
Table of Contents
