Setup Diagram; Getting Started - Planet VRT-401G User Manual

LAN 10/100M
(Port 1-4)
LAN LNK/ACT
(Port 1-4)
WLAN

Setup Diagram

Figure 1.2 below shows a typical setup for a Local Area Network (LAN).

Getting started

This is a step-by-step instruction on how to start using the router and get connected to the
Internet.
1) Setup your network as shown in the setup diagram above (fig 1.2).
2)
You then need to set your LAN PC clients so that it can obtain an IP address automatically.
All LAN clients require an IP address. Just like an address, it allows LAN clients to find one
another. (If you have already configured your PC to obtain an IP automatically then proceed
to step 3, page 13)
ON LAN port 100Mbps is connected
OFF LAN port 10Mbps is connected
ON LAN is connected
OFF No LAN connection
Flashing LAN port has Activity (ACT), data being sent
ON Wireless LAN has been activated
OFF Wireless LAN is disabled
Flashing Wireless LAN has Activity (ACT) data being sent
Figure 1.2
7