Planet VRT-401G User Manual page 59

Parameter
Enable Static Routing
Destination LAN IP
Subnet Mask
Default Gateway
Hop Count
Interface
Add a Rule
Remove a Rule
Description
Static Routing function is default disabled. You have to
enable the Static Routing function before your routing
rules take effect.
The network address of destination LAN.
The subnet mask of destination LAN.
The next stop gateway of the path toward the destination
LAN. This is the IP of the neighbor router that this router
should communicate with on the path to the destination
LAN.
The number of hops (routers) to pass through to reach
the destination LAN.
The interface that go to the next hop (router).
Fill in the "Destination LAN IP", "Subnet Mask", "Default
Gateway", "Hop Count" and "Interface" of the rule to be
added and then click "Add". Then this rule of Static
Routing will be added into the "Static Routing Table"
below. If you find any typo before adding it and want to
retype again, just click "Reset" and the fields will be
cleared.
If you want to remove some routing rules from the "Static
Routing Table", select the rules you want to remove in
the table and then click "Delete Selected". If you want
remove all rules from the table, just click "Delete All"
button. Click "Reset" will clear your current selections.
59