3-1-10 Editing I/O Comments - Omron DST1-ID12SL-1 Operation Manual

Editing Parameters

3-1-10 Editing I/O Comments

Note
I/O comments can be edited by setting the safety input terminals and safety
output terminals. The edited comments here are used as I/O tags in the Logic
Editor.
In the following procedure, separate I/O tags for safety input terminals and
safety output terminals are edited in one window.
1. Select Device - Edit I/O Comments. The following window will be dis-
played.
2. Edit each terminal comment, and then click the OK Button.
The following window will be displayed.
With Network Configurator Ver. 2.0@ or higher, the following procedure can be
used to replace I/O comments.
1. Click the Replace All Button in the window above. The following window
will be displayed.
2. Input the character string to be searched for and the characters it is to be
replaced with, and then click the OK Button. The comments will be re-
placed.
With Network Configurator version 2.0@ or higher, the following toolbar icons
will be displayed at the top of the Edit Device Parameters Window.
: Standard Mode
: Expansion Mode
These buttons can be used to switch between displaying or hiding expansion
parameters. Normally, device settings are made using only parameters dis-
played in Standard Mode.
Section 3-1
69