Moving The Machine - Ricoh M0A0 Service Manual


Removing jammed paper

Registering/changing/deleting data in the address book

Precautions on use

Connecting to computers (such as configuring the port setting)

Brief explanation of the tabs in the drivers

Moving the Machine


It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric shock.

Unplug the power cord from the wall outlet before you move the machine. While moving the machine, take
care that the power cord is not damaged under the machine. Failing to take these precautions could result in
fire or electric shock.

If you have to move the machine when the optional paper tray unit is attached, do not push on the main unit's
top section. Doing so can cause the optional paper tray unit to detach, possibly resulting in injury.

When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the cord
can damage the power cord. Use of damaged power cords could result in fire or electric shock.

The machine weighs approximately 23 kg (50.7 lb.). When moving the machine, use the inset grips on both
sides, and lift slowly in pairs. The machine will break or cause injury if dropped.
 Do not hold the control panel while moving the machine. Doing so may damage the control panel, cause a
malfunction, or result in injury.

Be careful when moving the machine. Take the following precautions:

Close all covers and trays, including the front cover and bypass tray.

If optional paper feed units are attached, remove them from the machine and move them separately.

Keep the machine level and carry it carefully, taking care not to jolt or tip it. Rough handling may cause a
malfunction or damage the hard disk or memory, resulting in loss of stored files.
1.
Be sure to check the following:
The main power is turned OFF.
The power cord is unplugged from the wall outlet.
The interface cable is unplugged from the machine.
2.
If any external options are attached, remove them.
3.
Lift the machine using the inset grips on both sides of the machine. Then move it horizontally to the place where
you want to use it.
4.
If you removed options, reattach them.
2.Installation
27