Pc5102-433 Software Default; Deleting Wireless Keys - DSC PC51O2-433NA Installation Manual

Hide thumbs Also See for PC51O2-433NA:

Table of Contents

If the PC5102-433 module does not show on the keypad, one of the following

conditions may be present:

• the module is not connected properly to the Keybus

• there is a problem with the Keybus wiring run

• the module does not have enough power

• no keys have been enrolled on the PC5102

NOTE: The PC5102-433 will be supervised and displayed as a PC5132.

4.3 PC5102-433 Software Default

Returning the PC5102-433 programming to factory default settings is a quick way to

remove all the enrolled wireless keys from the system and reset all the programming

in section [804].

NOTE

NOTE: Performing this procedure will not change any programming sections ex-

NOTE

cept [804]. Resetting the control panel to factory default settings will not return the

PC5102-433 module to factory default settings.

To restore the PC5102-433 programming to the factory default settings:

1. Enter [✱][8] [Installer's Code].

2. Enter programming section [996].

3. Enter the Installer's Code, followed by [996] again. The programming for the

PC5102-433 will be restored to its factory default settings.

4. To continue programming the unit, exit installer's programming by pressing [#]

and then re-enter installer's programming by entering [✱][8] [Installer's Code].

For instructions on restoring the default programming of the control panel or any

other connected module, see your system Installation Manual.

To remove a wireless key from the system, follow the guideline for enrolling a wireless

key (see section 3.2). Program the ESN as [000000]. The wireless key will then be

removed from the system.

Now that you have completed all PC5102-433 related programming, you can test

and mount the receiver. See Section 5 for more information.

Table of Contents