Table of Contents
Advertisement
S
E
T
2.3 Connecting the PC5102-433 Receiver
CAUTION: Remove all power from the system while connecting modules to the Keybus .
Connect the PC5102-433 to the four-wire Keybus of the control panel according to
the following diagram.
Control Panel
After you have completed the wiring, reconnect the power to the security system. Now
that you have wired the PC5102-433, you should enroll and program the wireless
keys. See Section 3 for instructions.
NOTE: Each control panel may either have a PC5102 or a PC5132 enrolled but not both.
2.4 Connecting the LED to the PC5102-433
The LED can be used to indicate whether the system is armed or disarmed. If the
output is programmed as an armed status output, the red LED will turn on when the
system is armed and will turn off when the system is disarmed.
ANT1
COM1
NO2
NO1
NC1
RED
BLACK
2.5 Connecting a Garage Door to the PC5102-433
Connect an output of the PC5102-433 across the wall-mounted push button or directly
at the motor of the garage door opener (please consult the garage door opener
instructions for proper connections). Set up the system and wireless key so that it is
programmed to pulse an output for a short duration (5 seconds) so that every time the
programmed key is pressed the garage door is opened or closed. The system can also
be set up so that an output on the PC5012-433 will follow a main panel output that is
programmed as a command output and is set up on the wireless key as such. Doing
this will also activate an output on the PC5102-433 for 5 seconds (please refer to the
control panel manual for a listing of available output types and their functions). PGM
1 and/or PGM 2 on the PC5102-433 can be set up to open a garage door (please refer
to Section 4.1).
ANT1
NO1
NC1
COM1
NO2
Garage door
pushbutton
or motor
U
P
RED BLK YEL GRN
KEYBUS TO
PC5102
NC2
COM2
RED
BLK
YEL
NC2
COM2
RED
BLK
YEL
&
W
GRN
GRN
4
I
R
I
N
G
Advertisement
Table of Contents
