Table of Contents
Advertisement
S
E
T
2.6 Connecting an X-10 Powerflash Module to the PC5102-433
When connecting an X-10 Powerflash module to the PC5102-433, different lights
within or outside the home can be controlled, such as table lamps, or porch and
driveway lights that illuminate the entry / exit paths.
This can be done by setting up the system and wireless key in one of several ways:
• The wireless key can toggle an output ON/OFF, triggering the X-10
Powerflash module, providing direct control of lighting.
• The wireless key can turn on an output for a programmable amount of time (5
seconds to 99 minutes and 99 seconds), turning on lights for the amount of
time the homeowner requires.
• The PC5102 output can be programmed to follow a main panel output which
can turn on lights when the panel is armed and turn them off when disarmed,
turn on lights when an alarm occurs and turn them off when disarmed, etc.
Please refer to the control panel Installation Manual for a listing of available
output types and their function. PGM 1 and/or PGM 2 on the PC5102-433
can be set up for this operation (see Section 4.1).
ANT1
NO1
NC1
COM1
NO2
Lamp
Module
X-10
Powerflash
Module
U
P
NC2
COM2
RED
BLK
YEL
&
W
GRN
5
I
R
I
N
G
Advertisement
Table of Contents
