Introduction; How To Use This Manual; Specifications And Features - DSC PC51O2-433NA Installation Manual

Hide thumbs Also See for PC51O2-433NA:

Table of Contents

This manual describes how to install, program and maintain the PC5102-433.

Before you install the PC5102-433 module, you should complete the following steps

in your system installation:

1. Plan the installation and wiring of the security system (see your system

Installation Manual ).

2. Install the control panel, and install and enroll at least one keypad to use for

programming.

Program the PC5102-433 from a system keypad or using DLS-3 v1.3 with the PC5102-

433 v1.0 Driver Pack. Read your system Installation Manual for more information.

Read this manual before you begin installing the PC5102-433. To install and set up the

PC5102-433 and wireless keys, follow these steps. Refer to the sections listed below.

1. Temporarily mount and wire the PC5102-433 module (see Section 2 ).

2. Enroll and program wireless keys (see Section 3 ).

3. Complete PGM and other programming on the system (see Section 4 ).

4. Test the placement of all the wireless keys (see Section 5).

5. Permanently mount the PC5102-433 receiver (see Section 5).

For additional information on trouble conditions and battery replacement, see

Section 6.

For help with troubleshooting, see Section 7.

• Current Draw: 50mA (standby) 200mA maximum (both outputs active)

• Frequency: 433 MHz

• Receiver can receive signals from up to 8 wireless keys

• Antenna - internal. Installation not required

• Location

- can be wired up to 750 ft/230m. from the main panel with 22 gauge wire

- connects to Keybus

- for longer wire runs, thicker gauge wire must be used

• Compatibility: The PC5102-433 v1.X can be connected to the following

panels: PC501X, P832/DL, PC5020, P-8+, PC1555, P-6B, PC1555MX, P-6BMX,

PC580, P-48

Introduction

Table of Contents