Identified Wireless Keys - DSC PC51O2-433NA Installation Manual

W I R
For systems using partitions (PC5020/P-8+/PC501X/P832/P832DL only): All wire-
less keys assigned to Partition 1 will have the four functions programmed in section [61].
All wireless keys assigned to Partition 2-8 will have the four functions programmed in
section [62-68]. For example, if function button 1 in Section [61] is programmed for Stay
arming, then pressing the first button on wireless keys assigned to Partition 1 will Stay arm
Partition 1.
NOTE: Wireless keys will not work when the partition they are assigned to is being NOTE NOTE
NOTE NOTE
accessed for zone bypassing or programming.
1. At a system keypad, enter [✱][8][Installer's Code].
2. Enter programming section [804].
3. Enter programming section [61] to [68] for partitions 1 to 8.
4. For each of the 4 function buttons, enter the 2-digit number of the function
you want to select. See the programming worksheets in the back of this
manual for a list of function key options.
5. Record your programming choices in the worksheets in the back of the manual.
6. To exit press [#].

3.3 Identified Wireless Keys

Reporting by the system of openings/closings by individual wireless keys and
command output [✱][7] activation by wireless key buttons may be supported on
certain control panels. To do this, the system will reserve access codes 17 – 24 for
wireless keys 01-08 respectively. You must program one access code for each
wireless key (using [✱][5] access code programming) for this feature to work
correctly.
NOTE NOTE
NOTE NOTE NOTE: Program these access codes on the system after you have connected the
PC5102-433 to the Keybus (see section 2.4).
Refer to your system Installation Manual for information on access code programming.
Opening/Closing By Wireless Key Reporting
NOTE NOTE
NOTE NOTE: The Identified Wireless Key Closing option is only available with the PC5020, NOTE
P-8+, PC501X v2.0 and higher, P832/DL v2.0 and higher, PC1555(MX), P-6B(MX),
PC580 v2.0 and higher, P-48 v2.0 and higher by turning section [015] Option 4 off.
To enable the reporting of openings and closings by identified wireless keys:
• Make sure the control panel is v2.0 or higher
• Program a valid access code for each key
• Program a closing and opening reporting code for each key's access code
• Turn off the Quick Arm option in section [015] option [4] of the control panel
programming
To ensure that an unidentified wireless key cannot disarm the system, turn off section
[017], option [1] (in the control panel programming). This option is available in control
panels with software version 2.1 or higher.
E L E S S D E
7
V I C E S