Swinger Shutdown; Hardware Default; Communicator Reset/Update - DSC LE4000 Installation Manual

LE4000 Reporting Codes
FTC Restoral
Firmware Update Successful
Firmware Update Fail
Firmware Update Begin
System Tamper
System Tamper Restore
* C24 Communications default value

6.7 Swinger Shutdown

To prevent "runaway" signals to the central station, the LE4000 is equipped with Swinger Shutdown which limits certain trouble
events to a maximum of four reports every 24 hours. At midnight, the condition restores and the counter is reset. Swinger Shutdown
applies to the following trouble conditions:
System Tamper/Restore
l
Low Battery Trouble/Restore
l
TLM Trouble/Restore
l
Input Power Trouble/Restore
l
FTC Restore
l
Zone 1 and 2 input alarm / restore
l

6.8 Hardware Default

A hardware default is required in order to update the unit with the latest configuration from C24 Communications. To perform the
hardware default, follow these steps:
The device was originally programmed incorrectly.
l
The unit was installed at a different location and then relocated to a new site.
l
A SIM card is being swapped.
l
To perform the hardware default, follow these steps:
1. Power down the unit and remove all connections to Zone1, Zone 2, PGM1 and PGM2. Note: When removing the battery,
depress the locking tab before attempting to detach the battery connector from the PCB. Failure to do so may result in damage
to the connector and/or battery.
2. Connect a wire between Z1 (terminal 5) and PGM1 (terminal 6).
3. Wait for 20 seconds and then completely power down the unit.
4. Disconnect the wire between the Zone and PGM terminals.
Note: If the unit has previously received programming from C24 Communications, a hardware default is required to initiate the down-
load of the latest configuration. Failure to do so results in the unit transmitting with the previously programmed configuration. A hard-
ware default must be performed when the SIM card is swapped.

6.9 Communicator Reset/Update

The device firmware can be updated over Cellular or PC-Link:
When the firmware update begins, all LEDs are ON.
l
RED
ON
During the firmware update process, the LEDs cycle individually in a chaser pattern (different from the Advanced Carrier
l
Selection pattern).
CID SIA Programmable
R354 000 YK 000 FIXED
R901 000 LS 000 FIXED
E902 000 LU 000 FIXED
E901 000 LB 000 FIXED
E145 000 ES 000 FIXED
R145 000 EJ 000 FIXED
Blue/Green (Top)
BLUE
ON
15
Comments
Communications Restored
Expansion Module Tamper
Expansion Module Tamper Restore
ON
6.7 Swinger Shutdown
Blue/Green (Bottom)
ON