Vf (View Frequency) & Vm (View Memory) Mode; Tuning Into Stations - Tecsun S-8800 Operation Manual

VF (View Frequency) & VM (View Memory) MODE
VF (View Frequency):
Press the [VF/VM] button on the radio
or remote control
alarm time is shown in the upper right
corner of the display, the VF mode is
activated. If it shows the preset station
number, press the [VF/VM] button again.
VM (View Memory):
Press the [VF/VM] button. When the
preset station number "P0XX" is shown
in the upper right corner of the display,
the VM mode is activated. If it shows the
clock or alarm time, press the [VF/VM]
button again.
Note:
When the memory contains no stored stations, it is not possible to switch
VF and VM mode; the device will automatically be in VF mode.

TUNING INTO STATIONS

Before tuning into FM or short wave stations, push the [INT ANT.] switch
proper position following the instructions about antenna usage as described in
section 8.
MANUAL TUNING
In VF (View Frequency) mode, rotate the [TUNING] knob
desired station. Alternatively, use the tuning options [
the remote control.
AUTO SCAN TUNING
In VF mode, press and hold the [VF/VM] button
on the remote control. The scanning indicator "
the device automatically scans the available stations, staying on each station for
about 5 seconds. To stop the auto scan function, rotate the [TUNING] knob
press the [SCAN] button
. When the clock or
on the remote control.
View Frequency display
View Memory display
to search for your
], [ ], [ ], and [
on the radio or [SCAN] button
" advances from left to right while
between
to the
] on
46
or
14