Auto Scan Memory - Tecsun PL-310 Operation Manuals

Special note:
During processing ATS with mode A in FM / MW / LW & SW, pre-stored radio stations
would be deleted & covered automatically by the new searched & stored stations. If ATS
is interrupted or being turned off during process, radio stations without deleted & covered
by ATS would still be kept.
With ATS mode B in SW, it will not delete & cover all existing memories; all the newly
found radio stations would be stored in the blank memories addresses.
STORING FREQUENCIES INTO MEMORY
1. Turn on your radio, and tune into your favorite station.
2. Short press [M] button, with the memory address is flashing in the display, press [M]
button again to confirm.
LISTEN TO STATIONS IN THE MEMORY
1. Turn on the radio, press and release the [SCAN MODE] button with notice that the
PRESET show in the display's upper right corner.
2. Turn the [TUNING] knob to listen to what's you stored.
DELETE MEMORY
1. Turn on the radio and press the [SCAN MODE] button, causing PRESET to appear in
the display's upper right corner.
2. Use the [TUNING] knob to select the memory that you want to delete.
3. Long press [DELETE] button. " DEL " is flashing in the display, press [DELETE] button
again to confirm it.
AUTO SCAN STATION
1. Turn on the radio and press the [SCAN MODE] button with n
flashes.
2. Long press [SCAN MODE] button to search for those available
stations. Auto search will stop on each available station for 3
seconds before it goes on searching for the next available
station.
3. To stop auto search function, simply press any buttons except
[M] button.

AUTO SCAN MEMORY

1. Turn on the radio and press the [SCAN MODE] button, causing
"PRESET" to appear in the display's upper right corner.
2. Long press [SCAN MODE] button until "PRESET" is flashing in
the display. It will search all the stations within the memory, and
stop on each station for 3 seconds.
3. To stop auto search memory, simply press any buttons except
[DELETE] button.
otice that Frequency