Tecsun S-8800 Operation Manual page 22

When using the remote control, in VF mode, you can directly key in the
frequency. Press the [M] button, then key in a memory location. Press the [M] button
again to confirm.
METHOD 2: Semi-auto storage
Radio operation: [VF/VM]
Remote control operation: [SCAN]
) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob
choose your desired FM/LW/MW/SW
band.
ii) Press and hold the [VF/VM] button.
The scanning indicator [>>] advances
from left to right while the device
automatically scans the available
stations, staying on each station for about 5 seconds.
iii) While operating the "Auto Scan" function, press the [MEMORY] / [M] button on
either the radio or remote control to store stations into memory, thereby avoiding
storing any unwanted stations. To stop the auto scan function, rotate the
[TUNING] knob
METHOD 3: Auto Tuning Storage (ATS)
Radio operation: [ATS]
Remote control operation: [FM]
While activating the ATS function through the below instructions, the frequency
advances and "PRESET" blinks in the upper right corner of the LCD. The memory
location indicator on the LCD changes when available stations are stored.
When the frequency stops running, it means the ATS operation has been completed;
all available stations are now stored into memory. Rotate the [TUNING] knob or
press the [ ] [
FM ATS
i) Turn on the radio, select VF mode and rotate the [BAND SELECT] knob
press the [FM] button on the remote control to choose FM band.
ii) Press the [ATS] button on the radio or press and hold the [FM] button on the
remote control to activate the auto tuning storage function.
19
and [MEMORY] buttons
5
or press the [SCAN] button on the remote control.
button
10
, [MW]
] buttons on the remote control to view all the stored stations.
46
9
and [M] buttons
and [SW-] [SW+] buttons
station
to
or