Table of Contents
Related Manuals for Tecsun S-2000
Summary of Contents for Tecsun S-2000
- Page 1 TECSUN TECSUN www.tecsun.com.cn R A D I O S A U S T R A L I A TECSUN RADIOS AUSTRALIA TECSUN RADIO CO., LTD. 24/9 Powells Road, Brookvale, NSW 2100 Australia Ph: +61 2 9939 4377 Email: info@tecsunradios.com.au www.tecsunradios.com.au...
-
Page 2: Features
FEATURES www.tecsunradios.com.au TECSUN TECSUN Thank you for purchasing TECSUN S-2000 receiver. Its features is shown as below: R A D I O S A U S T R A L I A 522-1620 kHz ( 9k Tuning Step) S-2000 520-1710 kHz... -
Page 3: Table Of Contents
............Internal or External aerials INT ：internal aerials QUICK START........................EXT ：external aerials TECSUN S-2000 PRODUCT ASSEMBLY DIAGRAM ............Sleep: Auto Turn off Timer for Radio S-2000 QUICK START GUIDE................... Alarm mode S-2000 OPERATION MANUAL " " Alarm by radio "... -
Page 4: Quick Start
“starts blinking on the LCD, then press DELETE button again to confirm. To an amplifier or a recorder. Please refer to the TECSUN S-2000 manual for QUICK DELETING and DELETING A PAGE. Press the RESET only when the radio seems to stop functioning properly. -
Page 5: Tecsun S-2000 Product Assembly Diagram
TECSUN S-2000 PRODUCT ASSEMBLY DIAGRAM www.tecsunradios.com.au 1. Battery compartment 19. AM aerial upper cover 2. Batteries 20. AM aerial lower cover 3. AC power cord compartment 21. Magnetic rod with coil 4. Battery contact springs 22. AM aerial plug 5. Back cabinet 23. -
Page 6: S-2000 Quick Start Guide
S-2000's clock is in 24 hours format and can be set with the radio on or off. When the radio is 1. Press the POWER button to turn on/off the radio. 2. Select FM by pressing the FM button, MW(AM) and LW by pressing the MW/LW button (press it turned off, the clock shows in mid-display. -
Page 7: S-2000 Operation Manual Power Supply
- The S-2000 has a battery power indicator in the - To delete the memory, press DELETE button with a "B" sound and notice that DEL flashes in the LCD. Fresh batteries will show a full power level display. -
Page 8: Storing Frequencies Into Memory
There are 1000 memories with S-2000. 500 memories fixed within P0 page, and 500 memories Press the POWER button to turn on the radio, select your band by pressing the FM, MW/LW, SW, set for other storage space. Please see bellows: or AIR button. -
Page 9: Listening To What's Stored
www.tecsunradios.com.au LISTENING TO WHAT'S STORED www.tecsunradios.com.au - Turn on the radio and go to the correct page by pressing PAGE and entering it with the numeric 3) AUTO SCAN (QUICK) STORAGE keypad or using the TUNING knob or button. - Press and release the VM/VF button with a "B" sound and notice the time shows in the upper PAGE / PRESET right corner of display. -
Page 10: Delete Memory
CLOCK SETTING www.tecsunradios.com.au www.tecsunradios.com.au The TECSUN S-2000's clock is in 24-hour format and can be set with the radio on or off. When DELETE PRESET MEMORY PAGE / PRESET the radio is turned off, the clock shows in mid-display. When the radio is turned on, the clock - Turn on the radio and press the VM/VF button with a "BB"... -
Page 11: Sleep Timer
1. Once the alarm is activated, no matter whether the radio is on or off, the alarm will force to The sleep timer enables the TECSUN S-2000 to play any length of play time from 1-120 minutes listen to the station that stored in TIMER A or TIMER B, or to make a sequential sound by the and then turn off automatically. -
Page 12: Using The Light Button
[mb] flashes on the top right corner of the display and the To use the SSB control, turn on the TECSUN S-2000 and go into Short-wave. Press the SSB lowest frequency of the meter band shows in the center of the button with a "B"... -
Page 13: Line Out Sockets
AUTO position, where it will function automatically, or you can turn it clockwise and use it another device to the TECSUN S-2000. Use a cord with a 3.5 mm (1/8 inch) stereo plug. manually to control the RF (radio frequency) gain. Using it manually may improve the radio's rejection of interference from adjacent frequencies that may interfere, especially on Shortwave. -
Page 14: External Antenna Sockets
SYSTEM CODE SETTING www.tecsunradios.com.au The external antenna sockets are used to connect the TECSUN S-2000 to advanced performance To enter different system codes turn off the radio and perform a quick, short press of the ENTER antennas. button with a "B" sound. "... -
Page 15: Troubleshooting
SPECIFICATIONS www.tecsunradios.com.au TROUBLESHOOTING www.tecsunradios.com.au PROBLEM PROBABLE CAUSE SOLUTION Frequency range 100-519kHz Can't turn on the radio (A) Power connection. (A) Check power supply cables. 522-1620kHz ----------------- system code "09" or no display or light. (B) Batteries are discharged (B) Check/re-install batteries for 520-1710 kHz (America) -- system code "10"... -
Page 16: Message Alert Status
www.tecsunradios.com.au MESSAGE ALERT STATUS www.tecsunradios.com.au AGC Performance AGC range: Wider than 80dB FUNCTION BUTTON OPERATION TONE DISPLAY Threshold : 12μV Light temporarily Light for 3 seconds. RF GAIN 20dB Light On/Off LIGHT/SNOOZE Light always Light until no power. Light off Turn off the light. - Page 17 MESSAGE ALERT STATUS MESSAGE ALERT STATUS www.tecsunradios.com.au www.tecsunradios.com.au FUNCTION BUTTON OPERATION TONE DISPLAY FUNCTION BUTTON OPERATION TONE DISPLAY Every operation Start or finish its operation. Mode alternation VF: frequency tuning mode Time shows in the upper right corner frequency and VM/VF Confirm or system An error occurred...