The RESET button is on the bottom of the Perform a RESET, as described in the DIAGRAMS ........................3 PL-600. When performing a reset, have section titled RESET PROCEDURE. GETTING STARTED ....................... 5 good batteries in the radio or power it with WHAT THE PL-600 INCLUDES ................
Page 3
'Meter Bands'. BAND (METERS) FREQUENCY RANGE Snooze Function: 10 minutes, repeated three times 2250 - 2550 The PL-600 offers two ways to access a 3150 - 3450 FM Stereo/Mono selection shortwave band. Each method places the 3850 - 4050...
PL-600 OWNER'S MANUAL 2 DIAGRAMS ADDITIONAL PL-600 CONTROLS continued USING THE LOCK BUTTON USING THE EXTERNAL ANTENNA 1. Power/ Sleep SOCKET 5. FM/Shortwave 2. Clock Button Pressing the LOCK button causes all Telescopic Antenna 3. Timer A Button button-activated controls to be 'locked' The external antenna socket is used to 4.
Page 5
MW LW Shortwave SSB Bandwidth N button labeled SYSTEM SET. The code Performing a three second press of the ICON (49) will briefly appear in the SYSTEM SET button, with the PL-600 36. Timer Activation Symbol Timer 42. SSB 44.
Divide the memories into 25 pages with 25:20 The battery compartment is located on the 20 locations back of the PL-600. Its cover is on the CHARGING BATTERIES IN THE PL-600 lower right corner of the back. To remove Divide the memories into 50 pages with...
(11). memory page. Each filled memory is Charging time varies depending on the charging, the PL-600 must be set up for 2. Press/hold the DELETE button (20) for accessed for about 5 seconds, after milliamp-hour rating of the batteries. The use with Ni-MH batteries and the correct 5 seconds and then release it.
6 WORKING WITH MEMORY TURNING THE PL-600 ON AND OFF VOLUME AND TONE CONTROLS At the factory, the PL-600 is set up with numeric keypad to enter the page or The volume control (31), labeled use the tuning knob to change the...
However, if there are three digits after the TUNING IN STATIONS 1. Turn on the PL-600 and tune to the There are four ways to tune-in stations, decimal point (e.g. 15.110 MHz or 5.975 desired station. described below. They are Manual MHz), use the method described 2.
A and B, Its purpose is to help minimize radio operators are easiest to find, best minute using the UP/DOWN buttons enabling the PL-600 to turn on and play interference. The preferred setting is results are experienced when using an (9, 10).