Table of Contents
Advertisement
Chapter 3.
You can print labels in these modes:
Printing in On-Demand Mode ––––––––––––––––––––––––––––––––
In on-demand mode, the printer prints and dispenses one label
at a time until the quantity downloaded is reached. To print
labels on demand:
1. Load the labels for peel mode. See Chapter 2, "Loading
Ribbon and Supplies."
2. The host sends print data to the printer.
3. After the data packet is downloaded, the LED rapidly blinks
green (1/4 sec) to indicate the printer is ready to print. The
first label in a batch prints about three seconds after the
printer receives the data stream.
4. Remove the printed label. The next label in the batch will
print. If it doesn't, press the trigger.
Trigger
Direct exposure to incandescent light may interfere with the
printer's on-demand sensor. If you are operating close to an
incandescent light source, you may need to use the trigger to
print the next label in the batch.
On-demand (peel mode)
Continuous (non-peel mode).
Printing
LED
3-1
Advertisement
Table of Contents
