Norelco ULTRASWITCH 100 User Manual page 5

behind the Ultra Switch 100 to program new parameters for the desired
functions. Please refer to Chapter 3 for the instructions on function
programming.
If you have a Caller ID device, you may connect your Caller ID in front of
the Ultra Switch 100 or connect it to the phone port of the Ultra Switch 100.
When connecting in front of the Ultra Switch 100, you should set the "Rings
to Answer" to 2 or more rings (please refer to page 16, "Rings to Answer"). If
the Caller ID is connected to the phone port of the Ultra Switch 100, you
should declare the availability of the Caller ID by programming the "device
availability" of the Ultra Switch 100 (please refer to page 19, Function Code
"7").
Whenever the Ultra Switch 100 answers a call and starts ringing a parti-cular
extension, the LEDs corresponding to another two extensions will blink in
accordance with the ring cycles. When the extension is answered, the two
LEDs stated above stop blinking and the LED corresponding to this
extension lights up.
Note: In certain cases, a Caller ID device connected to the Ultra Switch
100 may display calls in a different manner. Nevertheless, Caller
ID information is kept in memory if the device has the
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
WARNING!
2
capacity.