Norelco ULTRASWITCH 100 User Manual page 24

Function
Code
Security Code
9
◆
1:To set a Phone Filt
2
Note:
1. Yo
2.
Ex
Setting "4 5" as a Phone Access Code.
In this case, when setting in the Phone
Fil
access
connected to the Ultra Switch 100.
Description
Additional Program
(refer to page 20, Call Filter)
code (Phone Access Code)
:To delete a Phone Filter's security
code (Phone Access
u can set up to 5 Phone Access Codes for the Phone
Fil ter. If you attempt to set the 6th code, the Ultra Switch
100 will respond with a short tone and ignore this setting.
The Ultra Switch 100 scans the received code from the
most significant digit to the least significant digit and
compare w ith the pre-programmed code table digit by
digit. When a match is obtained, the Ultra Switch 100
starts operation immediately regardless the code scanning
being complete or not. As such, the Ultra Switch 100 will
never recognize a Phone Access Code 12 if 1 is the Fax
Access Code.
# * 9 1 4 5 *
ample:
ter mode, a cal ler must enter # 4 5 to
the telephone
ming:
er's security
Code)
which is
21
Default R ange of
Parameter
0-9
or
10-99
or
100-999