Norelco ULTRASWITCH 100 User Manual page 14

2:After the phone number, type several commas to provide a
delay until the Ultra Switch answers.
Note that for most computers, a comm
delay a certain period of time before performing the succeeding
operations. Determine the number of commas required based
on how long a call rings before the Ultra Switch 100 answers.
3: Af ter the com
To make sure that the Ultra Switch receives the M
Code correctly, type it several times consecu-tively. It is
therefore highly recommended that the Modem Access code to
be set in a repeated sequence such as 22, 33, or 444.
E xample: Suppose that your phone number is 218-0707, and
the Modem Access Code is 22, then typing of the following
code 2 1 8 0 7 0 7 , , , , 2 2 , 2 2 will instruct the Ultra
Switch to switch the line to the modem port.
4 :Press the Enter Key.
◆ To Enter the Modem Access Code Locally
Enter the Modem Access Code through a tone-dial telephone.
Note: If the code you entered is not the correct Modem Access Code,
you can make correction by pressing # to erase the previous
code first and then entering the Modem Access Code. Notice
that the code you entered previously may be a legal access code,
though it is not the desired Modem Access Code. In this case,
the line may be directed to the specific port corresponding to
that access code, as such, re-entering the Modem Access Code
can only be accepted before the line is answered by another
device.
mas, type the Modem Access Code.
11
a causes the computer to
odem Access