Installation - Norelco ULTRASWITCH 100 User Manual

The package of the Ultra Switch 100 itself contains the following parts list.
1. Ultra Switch 100
2. Power Adapter
3. RJ11 Phone Line Cord
4. Four Rubber Feet
5. Wall Mounting Kit
6. User Guide
7. Quick Reference Guide
If a part appears damaged or missing, contact your nearest Ultra Switch 100
location immediately. Save all packing materials. Reuse the package for
mailing if you experience a problem.
1. Remove the Ultra Switch 100 from the packing box. Stick the four rubber
feet to the edges of the Ultra Switch's bottom side to prevent possible
slide of this device.
2. Plug the connecting end of the 12VAC power adapter into the jack on the
rear panel of the Ultra Switch 100 labeled 12 VAC. Plug the other end of
the adapter into an AC power outlet. Once connected, the
indicator on the top of the Ultra Switch will light up.
3. Connect one end of the supplied phone cord to the jack labeled
Connect the other end of the line cord to the incoming telephone line
(C/O line). Connection of the Ultra Switch 100 in various situations are
illustrated in Fig.1-2, Fig.1-3 and Fig.1-4. Connect your communication
devices to their associated jacks at the rear panel of the Ultra Switch 100
as illustrated in Fig.1-1.
4. The Ultra Switch 100 is now ready for use. Indeed, it works with the
default parameters set by the control program. If you want your Ultra
Switch 100 to work differently, you may use any tone phone connected

1. INSTALLATION

STEPS TO GET STARTED
1
POWER
LINE-IN
.