Commissioning, Inspection, Maintenance - Viessmann Vitorondens 200-T Service Instructions Manual

Commissioning, inspection, maintenance

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Filling the heating system.................................................................................................
•
2. Vent the boiler at the safety equipment block (accessories).........................................
•
3. Venting the heating system
• •
4. Shutting down the system
• •
5. Draining the heating system (if required)........................................................................
• •
6. Opening the boiler door.....................................................................................................
• •
7. Cleaning the heating surfaces.......................................................................................... 10
• •
8. Checking gaskets and thermal insulation sections........................................................ 11
•
9. Fitting the boiler door........................................................................................................ 12
• •
10. Separating the neutralising system or active charcoal filter (if installed) from the
boiler and connecting the drain hose.............................................................................. 12
• •
11. Checking the neutralising system (if installed)............................................................... 13
• •
12. Checking the active charcoal filter (if installed).............................................................. 13
• •
13. Checking the connection on the flue gas side for leaks................................................ 13
• •
14. Cleaning the condensate drain pipe and siphon and reconnecting to the drainage
system................................................................................................................................. 13
•
15. Filling the siphon and neutralising system (accessories) with water........................... 14
• • •
16. Checking connections on the heating water and DHW sides and the sensor well for
leaks
• • •
17. Checking the function of the safety equipment
• •
18. Checking the expansion vessel and system pressure................................................... 14
• • •
19. Checking the thermal insulation for firm seating
• •
20. Checking the mixer for ease of operation and leaks...................................................... 15
• • •
21. Checking the ventilation air connection to the burner (if installed).............................. 15
• • •
22. Adjusting the burner.......................................................................................................... 15
•
23. Instructing the system user.............................................................................................. 15
•
24. Operating and service documents................................................................................... 15
6
Page
7
8
9
9