Installing Control Unit - Siemens SINAMICS G120 Operating Instructions Manual

Installing

4.6 Installing Control Unit

4.6 Installing Control Unit
Installing the Control Unit - General
Each Power Module has an appropriate holder for the Control Unit and a release
mechanism.
Inserting the Control Unit
Proceed as follows to plug the Control Unit onto a Power Module:
1. Place the two catches of the Control
Unit in the matching grooves of the
Power Module.
2. Press the Control Unit onto the
Power Module until you hear that it
latches.
You have now plugged the Control Unit onto the Power Module.
Removing the Control Unit
Remove the Control Unit from the Power Module by pressing the release mechanism.
Special features for the PM240 FSGX Power Module
To insert or detach the Control Unit, you must release the two screws
at the front cover, slightly shift the front cover upwards and remove
towards the front.
Reattach the front cover before you commission the device.
90
Converter with the CU240B-2 and CU240E-2 Control Units
Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC